JD - alliance Sanzo

Forum de l'alliance Sanzo. Ressources, informations, organisations des raids, ...

Vous n'êtes pas identifié.


L'url "http://www.jdsanzo.net" vient d'être crée. Il est possible qu'il y ai des problème d'identification. Merci alors de faire clique droit / ouvrir onglet pour s'identifier ;)
Au vue des problème technique de cette plateforme, je travail dès à présent sur une futur version ... l'url ne changera pas.

#1 26-07-2019 04:27:27

Date d'inscription: 03-08-2018
Messages: 67

Strategies of choosing a super Crusher

In most cases, the crushers are applied to crush the stones. In case the hardness in the supplies just isn't really large, a relatively low-grade crusher is usually preferred; when the hardness is really a little comparably substantial, a Construction Waste Crusher  of top of the range may be chosen. With out a proper choice, it may well do wonderful damage into the products. For the reason that crushers are primarily applied in the marketplace of sand creating, which happens to be large-scale generation, the productivity of single crusher can’t meet the needs, therefore, the match in the production line of crushers is needed urgently while in the market.

In general, the creation line of crushers consists of vibrating feeders, jaw crushers, impact crushers, screens, belt conveyor, concentrated electronic control, and other facilities, which targets to produce 50 to500 tons product per hour. To satisfy different consumers, the cone crushers and sand washers can also be added. The crushing generation line is usually a kind of common tools among the mine enterprises, which plays an important role during the output line of ores dressing. Being a mining machine, the generation line of crushers will meet faults unavoidably during the manufacturing and application.

The faults and causes of the line is often divided into several kinds by experts:

1. The base bearing on the output line gets heat and abnormal voice, with the engine overloading to deenergize. It might be caused by the following 5 reasons. Firstly, the oiling is not rationally given. Secondly, some mud and sand may get into the base bearing. Thirdly, the base bearing may perhaps be broken. Fourthly, the base bearing isn’t set up properly. Lastly, the quantity of feeding is either excessive or insufficient.

2. The crushing generation line has the phenomenon of vibrating. It may be caused by the following 4 reasons. Firstly, the wheel gear gets too much abrasion. Secondly, the ground screws or the bearing screws are loosened. Thirdly, the half bolts become flexible. Lastly, the drive bearing is over-broken.

3. The power source of your transmission device engine inside the generation line is instable or over significant. It may well be caused by the following 6 reasons. Firstly, the feeder is loosened. Secondly, the oiling is just not rationally given. Thirdly, the density of the ores discharge is too higher. Fourthly, the weight on the surrounding scaleboard is unbalanced. Fifthly, the wheels are over broken. Lastly, something is wrong with the circuit.

Here are some ideas of dealing with those questions. 1. Improve the oiling on the feeders. 2. Adjust the operation and change the scaleboard. 3. Fix or mend the wheel gears. 4.Eliminate the electricity fault.

Hors ligne


Pied de page des forums

Créez Votre Propre Forum
Insérer vos Graphiques
Dictionnaires de Traduction
Hébergé par ForumCrea.com