JD - alliance Sanzo


Forum de l'alliance Sanzo. Ressources, informations, organisations des raids, ...

Vous n'êtes pas identifié.

Annonce

L'url "http://www.jdsanzo.net" vient d'être crée. Il est possible qu'il y ai des problème d'identification. Merci alors de faire clique droit / ouvrir onglet pour s'identifier ;)
Au vue des problème technique de cette plateforme, je travail dès à présent sur une futur version ... l'url ne changera pas.
merci.

#1 24-07-2019 04:32:35

autcrusher
Membre
Date d'inscription: 03-08-2018
Messages: 45

Some Things Affecting Sand and Gravel Mixture

We use quality stone to pave road, it not only has the pure good mechanical index, but its particle shows e-shaped and multi-angular immediately after crushing so as to ensure the near blend within the stone and enhance the overall power of the street. Also, the area from the stone present multi-angular and rough texture, that may be bonded using the asphalt firmly, therefore the strength and durability on the pavement is better. For your whole generation of ore exploiting, it is vitally significant to manage the finished products content material of your flat-shaped and prolate-shaped particles, which can make Construction Waste Crusher   high-quality criteria.

one. Ratio of reduction: ratio of reduction is dimension percentage of material to become feed and the finished product. In the event the ratio is bigger, the ratio of reduction is greater. This rule not just utilize jaw crusher not also cone crusher. Ratio of reduction has nothing at all to carry out with the crusher models, but if the ration of reduction is just too little, it may possibly direct to scale back output, improve inner recycle and the wear with the crusher, and so the overall economy is weak as well as the output effectiveness is minimal. Thus, it is very critical to pick the correct ration of reduction in the overall production progress.

two. Sizing of input granules: in the event the feed sizing reduces from 100mm to 50mm, flakiness material in the concluded compound lowered by 38%.

three. Cyclic Loading: inside the course of action of shut loop generation, increasing discharge opening and cyclic load make stone grain improved, since cyclic load elevated can lead to the damage of technique gear. But once the discharge opening transfer larger sized, the primary motor load of crusher can reduce, which can make the finished feed grain much better.

4. Open and closed circulation: in the secondary crushing method, circulation is divided into open up circulation and closed circulation. Open up circulation could be the very first screening right after crushing, which refers to the major damaged material is screened by vibrating screen and enters in to the feeder of your secondary crushing, to ensure the completed content creation and flakiness written content are increased. Closed circulation would be the 1st crushing just after screening, which refers to which the primary damaged materials enters in the secondary crushing feeder completely and crushed, and afterwards screened by vibrating screen. All the program has no materials loss, plus the product or service of grain form is healthier.

On top of that, the right grain condition is larger sized when compared to the discharge opening in accordance with the concluded content particle measurement. Discharge opening is larger sized in comparison to the particle measurement which can be lessen than that discharge opening is lower than flakiness information. It is because when discharge opening using the exact as feeder is smaller, the ration of reduction is massive, so the particle condition appears variation.

Hors ligne

 

Pied de page des forums

Créez Votre Propre Forum
Insérer vos Graphiques
Dictionnaires de Traduction
Hébergé par ForumCrea.com